The ULTIMATE GameCube + GBA Player!! (Pluto II, Picoboot, Xeno, Etc!)

Description: A GameCube DOL-001 has been reshelled with a white translucent shell. Included with this is a Gameboy player (black) and an extensive list of hardware and software mods! Please see below for the extensive list: Pluto II GCHD: The digital AV OUT port has been replaced by the pluto HDMI board, which allows for sharper pixels and crisper viewing angles! No bulky adapters or expensive GameCube component cables here! To access the settings menu, hold L+R+X+Y. In this menu: X-Button: Enter, Y-Button: Back. Note: Some displays may experience problems with audio. Make sure Enhanced DVI mode is toggled ON PicoBoot: A pico raspberry pi has been installed to allow immediate boot into SWISS (The Gamecube Homebrew menu). From here, you can play GameCube ROMs (.DOL) saved on your SD card (games NOT included with this purchase) and you can boot GameBoy Interface! Gameboy Interface replaces the need for the GameBoy Player startup disc to play GB/GBC/GBA games. It’s also far superior in both graphics AND customization to the startup disc. Note: In order to boot into SWISS, the included SD card/SD Card Gecko MUST be inserted in the memory card slot. To play GameCube normally, simply remove the SD Card Gecko SWISS Applications: To make for easy day 1 use, the following GameCube applications have been downloaded onto the included SD card. Here is a walkthrough of what the SWISS Menu will look like: Gameboy Interface (Folder): Folder will contain Three versions of GameBoy Interface: Speed running (zero latency, worst graphics) High fidelity (minor latency, best graphics), standard (a mix of the two previous versions). To boot, select the .dol file. The .cli file will contain options on graphics and button mapping. To alter these, eject the SD card, open the file as a .txt on your computer and make changes! Games (Folder): This will be empty. Place your LEGALLY SOURCED .iso files here to play games! GameCube Memory Manager (Folder): Here, you will be able to backup and restore your save files. Just have to make sure that a memory card is also plugged in (in addition to the SD Gecko/SD card) MCBACKUP (Folder): This is where the above application (GCMM) will back up your saves. Additionally, if you would like to restore a save file, place the file in this folder and the GCMM application will read from here SWISS&SWISS_r1668: Ignore these, needed to be read by Pico board to boot into Swiss Xeno Chip: A modchip has been installed onto the disc drive to allow for the GameCube to read games region free! Normally the GameCube is region locked. This chip fixes that 😊. NTSC-U, NTSC-J, and PAL games all supported! Custom LED and RTC Battery replacement: A custom, red LED has replaced the original orange LED to give the ‘cube a sharper look! The 2032 CR battery has been replaced, and a battery holder has been added to make for easy replacement in the future. An SD Gecko/ 16 Gb SD card will also be included (this will contain all CFW data) Controller, power cord, hdmi cables not included

Price: 399.99 USD

Location: Rockville, Maryland

End Time: 2024-11-11T14:34:31.000Z

Shipping Cost: N/A USD